Official Samsung Galaxy J2 SM-J200M Stock Rom

```html

How to Install Official Samsung Galaxy J2 SM-J200M Stock Rom

If you own a Samsung Galaxy J2 SM-J200M smartphone and want to restore it to its original factory settings, you can use the official stock firmware from Samsung. This firmware will help you fix any software issues, such as bootloop, stuck on logo, or IMEI problems. It will also update your device to the latest Android version and security patch.

In this article, we will show you how to download and install the official Samsung Galaxy J2 SM-J200M stock rom using Odin flash tool. You will need a Windows PC, a USB cable, and some drivers and files to complete this process. Please follow the steps carefully and backup your data before proceeding.

Disclaimer

This guide is for educational purposes only. We are not responsible for any damage or data loss that may occur to your device during or after the installation of the firmware. Proceed at your own risk.

Requirements

A Samsung Galaxy J2 SM-J200M device with at least 50% battery charge.

A Windows PC and a USB cable.

Samsung USB drivers installed on your PC. You can download them from here.

Odin flash tool downloaded and extracted on your PC. You can download the latest version from here.

The official Samsung Galaxy J2 SM-J200M stock firmware file downloaded and extracted on your PC. You can find the firmware for your region and carrier from here or here.

Steps to Install Official Samsung Galaxy J2 SM-J200M Stock Rom

Turn off your device and boot it into download mode by pressing and holding the Volume Down, Home, and Power buttons together for a few seconds. Release the buttons when you see a warning screen and press Volume Up to confirm.

Connect your device to your PC using the USB cable. Odin should recognize your device and show a blue or green box in the ID:COM section.

Click on the AP button in Odin and browse to the folder where you extracted the firmware file. Select the file that ends with .tar.md5 extension and click on Open.

Make sure that only Auto Reboot and F. Reset Time options are checked in Odin. Do not check any other options or change any settings.

Click on Start button in Odin to begin the flashing process. Wait for a few minutes until you see a PASS message in Odin.

Your device will reboot automatically and boot into the new firmware. You can disconnect your device from your PC and enjoy the official Samsung Galaxy J2 SM-J200M stock rom.

Conclusion

In this article, we have shown you how to install the official Samsung Galaxy J2 SM-J200M stock rom using Odin flash tool. This firmware will help you restore your device to its original factory settings and fix any software issues. We hope this guide was helpful for you. If you have any questions or feedback, feel free to leave a comment below.

``` aa16f39245